Shop Malossi Scooter Performance Parts - Yamaha Zuma Race Reed Petal Set Malossi Karbonit for VL10 Reed Valve Assembly for Minarelli Vertical Engines
For Yamaha Zuma pre-2001 USA versions with Vertical Engine. Malossi Racing Membrane plates control the gas exchange process in the inlet area. They open during the intake process and close during the pre-compression in the crankcase. How fast this process takes place has a significant influence on the throttle response (liveliness) of the engine.
By default, original membrane blocks are usually equipped with very sluggish or even steel plates. This has two disadvantages: The engine responds only good-naturedly to the gas command and these original tiles can destroy the entire engine in case of a defect.
Malossi helps with these fiberglass membranes in different strengths. This allows you to tailor the response individually to the requirements. Thinner platelets respond better at lower speeds, thicker ones better support the engine in the highest speeds. Fiberglass tiles usually disappear in the exhaust without damaging them, should they break.
Delivered is a set of 0.30mm, 0.35mm and 0.40mm suitable for the VL10 diaphragm block for scooters with Minarelli standing engines.
For Yamaha Zuma pre-2001 USA versions with Vertical Engine. Malossi Racing Membrane plates control the gas exchange process in the inlet area. They open during the intake process and close during the pre-compression in the crankcase. How fast this process takes place has a significant influence on the throttle response (liveliness) of the engine.
By default, original membrane blocks are usually equipped with very sluggish or even steel plates. This has two disadvantages: The engine responds only good-naturedly to the gas command and these original tiles can destroy the entire engine in case of a defect.
Malossi helps with these fiberglass membranes in different strengths. This allows you to tailor the response individually to the requirements. Thinner platelets respond better at lower speeds, thicker ones better support the engine in the highest speeds. Fiberglass tiles usually disappear in the exhaust without damaging them, should they break.
Delivered is a set of 0.30mm, 0.35mm and 0.40mm suitable for the VL10 diaphragm block for scooters with Minarelli standing engines.
